The connectors are black in a 40-pin connector while in an 80-pin connector, they come in 3 colors: blue - controller, gray - slave drive, and black - master drive. 80-pin connectors were also introduced later. ESATA cables can be 2 m in length.IDE consists of a 40-pin connector attached to a ribbon cable. Parallel ATA only allows data cable lengths up to 18 in (457 mm) while SATA allows cable lengths up to 1 m (3.28 ft).
What Kind Of Solid State Drive Do I Need For A Powerbook 2010 How To Change TheAdapters are also available that allow an IDE drive to be used with a SATA motherboard and vice versa. However, only one of the two may be used at any given time and both cannot be used simultaneously. It has the facility to attach only one drive and so Serial ATA does away with Master/Slave configurations.This video explains how to change the hard drive on a desktop computer it also shows the differences between SATA and IDE connector cables.You can buy integrated motherboards that allow a computer to use both SATA and IDE hard drives.![]() ![]() ESATAp port combines the strength of both eSATA (high speed) and USB (compatibility) into a single port.Data transfer speed for IDE ranges from 5MB/s up to 133MB/s (ATA100/133). In order to overcome this limitation, eSATAp drives were introduced. ESATA cannot supply power from the motherboard to the hard drive. ESATA is meant for external connectivity. They usually cost less than $15.Two variant of SATA - eSATA and eSATAp - are available. The narrower SATA cable allows free airflow inside the case.SATA drives have an additional feature of Hot plugging which mean that even as the computer is running drives can be removed or added.PATA (IDE) drives need 5 volts and 12 volts in desktop form factor.SATA drives use 5 & 12 volts & 'can' include 3 volts as wellBut nearly all current disk drives do not use the 3.3 V line.SATA has also done away with the master/slave configuration (technically, device 0 and device 1) used in IDE drives. Today the third generation of SATA (3.0) (released on May 27, 2009), 6 Gbit/s (600 MB/s) hard drives and motherboards are being used.The wide wire in IDE cables caused airflow problems inside the case. The first generation of SATA was 1.2 Gbit/s (150 MB/s note that MB is mega bytes and Gb is giga bits) similar to PATA/133. Best mac software for backing up to dropboxMany SATA drives can connect to the motherboard via multiple ports, and the drive to boot from is specified in the BIOS settings. For hardware, this usually meant setting the right jumper settings.But the SATA bus is a serial point-to-point bus, which means only one device can be connected on each channel.
0 Comments
Leave a Reply. |
AuthorDaryl ArchivesCategories |